This change is made clearer if you update to v6.0.5 (or later) of Weatherlink for Windows as described in the Download topic. The ‘User’ field now requires the DID for the WLIP logger to be entered rather than the account username as previously. ! Downloading archive data from to local Weatherlink for Windows Remember that the credentials required for these downloads changed with the introduction of v2. The various issues covered below relate specifically to the WLIP logger and will not be relevant to e.g. *This topic relates only to the 6555 WeatherlinkIP ( WLIP) logger product, ie the logger with the Ethernet interface that connects into a network rather than cabling directly to a PC. Customising the Weatherlink console Display screen Davis 6313 Weatherlink Console – Overview It will display diagnostic information, as shown in the circled area above. To access this information, quit WeatherCat and connect to the data logger with your web browser using the IP address you have assigned to it. Note that the WeatherlinkIP Configuration page can also be used to obtain additional diagnostic information if you are having communication issues with the data logger. You can now close the WeatherlinkIP Configuration tab in your browser and start WeatherCat. All other settings should not need to be changed. Do not use the IP address and other settings shown in the example above unless they are correct for your internal network. Enter the Subnet Mask, Default Gateway and DNS Server addresses as appropriate for your internal network. Enter the IP address you previously reserved in the router. Then check the option to Use the following IP Address. Once you see this page in your browser, uncheck the option to Obtain an IP Address Automatically. Type the IP address of the data logger identified by your scanner app into your browser and it will open up the WeatherlinkIP Configuration page similar to the one show below. WeatherCat cannot be running while you complete this step. They will identify Davis Instruments as the manufacturer and also give you the MAC address.įor the next step, you must shut down WeatherCat. These free apps scan your network and identify all of the IP addresses being used. You can also us an iOS app, such as Fing. This is done, using an IP scanner on your computer, such as LanScan. You need to discover the IP address it is using. When you first power up and connect the data logger via ethernet, it will automatically find an IP address, which will not be the address you reserved for it in your router. After the data logger is installed, power the console back up with its power cord and then install the batteries. If you have batteries in the console, remove them, then unplug the power cord. The data logger should never be installed (or removed) from the Davis Console unless the console has been completely powered down. The MAC address of the data logger is printed on its factory label. Before installing the data logger into the back of your Davis console, reserve an IP address for it on your router using its MAC address. It can be connected to an Apple Airport Express in the event that you do not have a wired ethernet port in the desired location for the placement of your console. The Davis WeatherLinkIP data logger should be run using a static IP address on your home network.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |